310 CHAPTER 10: CONFIGURING ROUTING AND TRANSLATION SERVICES
d Select the new route plan by enabling the radio button preceding the
route plan name.
e Click Next (lower right corner of the Wizard page).
The second page of the Route Wizard appears. See Figure 119
.
Figure 119 Route Plan Wizard - Page 2
As shown in Figure 119, the page lists previously configured end points.
You have the following two options:
■ You can create an end point, then add it to the route plan. Go to
step 3
.
■ You can add an existing end point to the route plan. Got to step 4.
3 To create an end point:
a Enter a name for the end point in the Name text box.
b Enter the site identifier for this end point in the Site Id text box. The
site ID is typically the pattern (prefix) dialed by a caller to reach a
regional or branch office.
c The IP Port field specifies the port number used by the end point. The
default port number is 5060.
■ If this end point identifies an IP Telephony and IP Messaging server,
or an IP Telephony server, accept the default port number 5060.
