4-20 Installing Options
Note
:
After the processor cartridge is
removed or replaced, the processor jumpers on
the system board must be reset (see “Processor
Jumper Settings” in Chapter 3).
Removing a Celeron or Pentium III Processor
Remove the Celeron or Pentium III processor cartridge from
its Slot 1 socket and universal retention mechanism on the
system board as follows.
!
CAUTION
Before handling components, reduce static
discharge by touching the chassis.
1.
Power off the system and remove the left side cover (see
“Removing the Left Side Cover” earlier in this chapter).
2.
Position the system on its right side for easier access to
the system board and processor cartridge.
!
WARNING
If the system was just running, the processor
cartridge and heat sink on the system board are
hot. To avoid a burn, let the components cool for
about 10 minutes before continuing.
3.
Locate the processor cartridge on the system board (see
the figure “System board sockets and connectors” earlier
in this chapter).
