Configuring the System 3-17
Advanced Menu - Peripheral Setup
Menu Item Settings (default is bold)
Serial Port B Mode
Normal
, IrDA, ASK IR
Selecting Normal sets the port for normal
use, not for IR use.
IR Duplex Mode N/A
IrDa Protocol
N/A
Onboard Parallel Port Auto, Disabled,
378
, 3BC
Select Auto to allow the BIOS to
automatically assign the parallel port to an
available parallel port IRQ.
Parallel Port Mode Normal,
Bi-Dir
, EPP, ECP
Use this mode to choose the operating mode
of the onboard parallel port.
EPP Version Use this setting (1.7 or 1.9) to select the EPP
version.
Parallel Port IRQ
Parallel port 7
Setting depends on setting of Parallel Port
Mode. If not set at auto, you can select the
interrupt line for the onboard parallel port.
Parallel Port DMA Channel This option allows you to choose DMA
channel 1 to 3 for the onboard parallel port in
ECP mode.
Onboard IDE Disabled, Primary, Secondary,
Both
The Both setting enables both the primary
and secondary IDE controllers.
Hard Disk Delay Time Disabled, 3 sec.,
6 sec
., 9 sec., 12 sec., 15
sec., 21 sec., 30 sec.
The hard disk delay time gives the hard disk
time to spin up before the system boots.
