Installing Options 4-33
Removing an Expansion Board
To remove an expansion board, use the following steps.
1. Remove the left side cover (see “Removing the Left Side
Cover” earlier in this chapter).
2. Label and unplug any cables connected to the board.
3. Remove the screw that secures the expansion board to the
chassis. Save the screw.
4. Pull the board out of the connector and expansion slot.
Set the board on an antistatic surface.
5. Install a new board or install the slot cover if you are not
installing a board. Secure the board or slot cover with the
previously removed screw (see “Installing an Expansion
Board” in the previous section).
6. Replace the left side cover (see “Replacing the Left Side
Cover” earlier in this chapter).
AGP Board
The system board has a dedicated AGP board connector for
the AGP graphics board shipped with your system. If you
need to remove the existing board and install another AGP
board, use the following procedures.
Removing the AGP Graphics Board
Remove the AGP board as follows.
1. Remove the left side cover (see “Removing the Left Side
Cover” earlier in this chapter).
