Installing Options 4-7
Replacing the Left Side Cover
Replace the left side cover as follows.
!
CAUTION
Ensure that all cables are positioned to prevent
crimping, abrasion, or cutting while installing the
cover. Check that the ribbon cables are folded
along their fold lines and out of the direct path of
the cover.
1.
Position the side cover over the side of the chassis so that
the back edge of the cover is about an inch beyond the
back edge of the chassis (see the following figure).
2.
Fit the flange on the bottom of the cover over the rail
along the bottom edge of the chassis.
3.
Align the lock tab slot at the bottom rear of the cover with
the lock tab.
4.
Align the tabs on the top of the cover with the top slots on
the chassis.
5.
Firmly press the cover against the chassis and slide the
cover towards the front of the chassis until it locks in
place.
Note
:
If the left side cover does not slide all
the way to the front of the chassis, check that the
cover tabs at the front of the cover are properly
inserted into their slots in the chassis.
