Installing Options 4-21
4. If necessary, remove the AGP graphics board and any
other expansion board(s) blocking access to the processor
(see “Removing the AGP Graphics Board” or see
“Removing an Expansion Board” later in this chapter).
5. If the processor cartridge has an attached cooling fan, tag
and unplug the fan cable from its connector on the system
board.
6. At one end of the processor cartridge (see the following
figure), carefully pull the locking lever away from the
cartridge approximately 1/4-inch. The lever requires a
strong steady pull to release the cartridge.
7. While holding the locking lever out, carefully pull up on
the end of the cartridge to release the end from the
retention mechanism.
Removing the Celeron or Pentium III processor cartridge
A
– Locking Lever
C
– Processor Cartridge
B
– Universal Retention Mechanism
