Filter
Top Products
Configuring Network Channels
4-13
Figure 4-15 Prompt for Additional Channels
10 Do one of the following:
■ Select
No
to exit the configuration procedure, and
go to the next section (“Editing the AUTOEXEC.NCF
File”) to continue the installation.
■ Select
Yes
to configure an additional channel. The
maximum is four channels (Channel 1 plus three
additional channels).
The dialog box in Figure 4-16 appears.
Figure 4-16 Reselect the Driver for Additional Channels
The dialog box in Figure 4-16 is the same dialog
box as shown in Figure 4-6. However, this time the
driver is obtained from the NetWare server’s hard
disk instead of the installation diskette. Each
channel requires the installation and configuration of
a 3C971-F adapter driver.
11 Select the
3C971FSI.LAN
in the driver selection
dialog box shown in Figure 4-16.