Filter
Top Products
5 Installing NetWare Drivers
42
Installing the NetWare Driver Using INETCFG
To install the NetWare driver:
1 Copy the MSM.NLM, ETHERTSM.NLM, and NBI.NLM files from the NWSERVER
directory on the EtherCD to the system directory; or use the latest service pack
from Novell.
The NLM file location is typically in the SYS:SYSTEM directory. You need a NetWare
client system to copy the NLM files to the server.
2 Insert installation diskette 2 in drive A.
3 At the server prompt, enter:
load inetcfg
The Internetworking Configuration screen appears.
4 In the displayed menu, select Boards, and then press Enter.
5 Press Insert.
A list of currently installed drivers appears.
6 Press Insert again.
The New Driver dialog box appears.
7 Enter the directory:
a:\nwserver\3c99x.lan
An updated list of installed drivers appears.
8 Select 3C99x, and then press Enter.
You are prompted to name the NIC, for example: 3c99x_1.
9 Type the name of the NIC and press Enter.
You are prompted for the slot number. For information on how to verify the slot
number, see “Verifying the PCI Slot Number” on page 43.
10 Enter the slot number, and then press Enter.
11 Press Esc, Enter (to save), and then Esc.
The Internetworking Configuration screen appears.
12 Select Bindings, and then press Enter.
The configured protocols for installed NICs appears. (This list is empty if no protocols
are currently bound to the NIC.)
13 Press Insert.
The Select From the List of Configured Protocols screen appears.
For NetWare 5.x or 6x:
■ The default To a Network Interface is selected. Press Enter.
The Select a Configured Network Interface screen appears.
■ Select the board. For example, enter: 3c99x_1, and then press Enter.
14 When prompted, enter the network number, and then press Enter.
15 In the Frame Type field, press Enter to display a list of frames, choose a frame, and
press Enter.
NOTE: Copy the NLM files only if the versions existing on the server are older
than the versions supplied on the EtherCD.