Filter
Top Products
170 CHAPTER 6: CONFIGURING WX SYSTEM PARAMETERS
Custom Service Profile—Provides wireless access based on the
combination of options you choose. (Use this option only if none
of the other options applies to the type of service you want to
offer.)
b See “Viewing and Configuring Wireless Services” on page 235 for
information about wireless service parameters.
c When you are finished configuring wireless services, click Next and go
to step 8.
9 Configure basic Auto-DAP profile settings:
a To enable the Auto-DAP profile, select Enabled.
b To change the radio type the profile assumes for 802.11b/g radios in
dual-radio MAP models, select the radio type from the AP Radio Type
drop-down list:
11b
11g
10 Click Finish.
Modifying Basic
Switch Parameters
Basic switch parameters are displayed in the Content panel when you
select a switch in the Organizer panel.
1 Select the Configuration tool bar option.
2 In the Organizer panel, select the WX switch.
Basic parameters for the switch appear in the Content panel.
3 To modify the name, edit the string in the WX Name box.
4 To modify the serial number, edit the string in the Serial Number box.
Modification of the serial number applies only when you are prestaging a
specific switch. This option does not change the serial number of an
installed switch.
5 To modify the system IP address and VLAN, select them from the System
VLAN/IP drop-down list.
The system IP address determines the interface or source IP address MSS
uses for system tasks, including the following:
Mobility Domain operations
Topology reporting for dual-homed MAP access points