Filter
Top Products
DUA1640-5AAA02
6-8
C
HAPTER
6: U
SING
THE
C
OMMAND
L
INE
I
NTERFACE
Setting the IP
Configuration
Before you can manage the hub over the network, you must assign it
an IP address and subnet mask. You may also need to enter a default
router (sometimes known as the default gateway) address. The default
router is the router (if you have one) which is used by the stack to
communicate with other networks. For serial management, you may
need to configure the SLIP address and SLIP subnet mask.
If you have no previous knowledge of IP, refer to “IP Addresses” on
page 5-7
. If you change any of these values, you may need to re-access
the hub using the new values.
To enter new IP settings:
1
At the top-level menu, enter:
ip interface define
2
You are prompted for the hub’s IP address:
Enter IP address [0.0.0.0]:
Enter a valid IP address for the Hub.
3
You are prompted for the hub’s subnet mask:
Enter subnet mask [255.255.255.0]:
Enter a subnet mask.
4
You are prompted for a default router address:
Enter default gateway [0.0.0.0]:
Enter a default gateway address or press [Return] if it’s not needed.
5
You are prompted for a SLIP address:
Enter SLIP address [192.168.101.1]:
Enter a SLIP address or press [Return] if it’s not needed.
6
Finally, you are prompted for a SLIP subnet mask:
Enter SLIP subnet mask [255.255.255.0]:
Enter a SLIP subnet mask or press [Return] if it’s not needed.