Filter
Top Products
Ethernet+Modem/Fax PC Card User’s Guide
3-6 Using 1Step
Press <F1> to activate on-line help and select the driver you need. The
corresponding README.TXT file containing driver installation instructions will
be displayed.
The following are the Network Operating Systems supported by Accton’s 1Step:
NetWare Workstation version 4.0, 3.x, 2.x, Lite, and Lite Server
LAN Manager 2.0 and 2.1
LAN Support Program 1.2 and 1.3
DEC Pathworks
Banyan Vines
Sun PC-NFS
Wollongong Pathway Access
Windows for Workgroups 3.10 and 3.11
Note: 1Step automatically loads the NETX.EXE NetWare Shell program by
default. You need to save at least one drive letter for the login directory
when the NetWare client is initiated by setting the Lastdrive statement in
your CONFIG.SYS file to any available drive letter except Z. This will cause
the NetWare Client software to assign the next letter as the Client login
directory.
e.g., Lastdrive=Y Lastdrive statement in CONFIG.SYS
Z:\>Login NetWare Client login directory assigned
If you opted for the NetWare DOS requester (VLM.EXE), You need not
worry about the “LASTDRIVE=” statement. If you set the
“LASTDRIVE=” to any letter other than Z, you may get warning
messages. Ignore them.
Selecting the Driver
The PC Card provides support for NetWare and NDIS drivers. Install the driver
you need depending on your NOS.
Selecting the Frame Type
Select the Frame Type appropriate for your adapter from the choices provided.
The Card provides four selections, which include Ethernet 802.3, Ethernet II,
Ethernet 802.2 and Ethernet SNAP. The factory default frame type is Ethernet
802.3 for NetWare 3.x and Ethernet 802.2 for NetWare 4.0.