Filter
Top Products
Ethernet+Modem/Fax PC Card User’s Guide
Modem AT Commands and S-Registers B-3
Table B.1 AT Command Summary (cont.)
Command Description Usage Default
ATX0
Basic call
progress result
codes report
Report basic call progress result
codes, i.e., OK, CONNECT, RING, NO
CARRIER (also, for busy, if enabled,
and dial tone not detected), NO
ANSWER and ERROR.
N
ATX1
Basic call
progress result
codes and
connection
speeds report
Report basic call progress result codes
and connection speeds, i.e., OK,
CONNECT, RING, NO CARRIER (also,
for busy, if enabled, and dial tone not
detected), NO ANSWER, CONNECT
XXXX, and ERROR.
N
ATX2
Basic call
progress result
codes and
connection
speeds report
Report basic call progress result codes
& connection speeds, i.e., OK,
CONNECT, RING, NO CARRIER (also,
for busy, if enabled, and dial tone not
detected), NO ANSWER, CONNECT
XXXX, and ERROR.
N
ATX3
Basic call
progress result
codes and
connection rate
Report basic call progress result codes
& connection rate, i.e., OK, CONNECT,
RING, NO CARRIER, NO ANSWER,
CONNECT XXXX, and ERROR.
N
ATX4
Basic call
progress result
codes and
connection rate
Report basic call progress result codes
& connection speeds, i.e., OK,
CONNECT, RING, NO CARRIER (
also, for busy, if enabled, and dial tone
not detected), NO ANSWER,
CONNECT XXXX, BUSY, NO DIAL
TONE, and ERROR.
Y
ATY0
Disable long
space disconnect
before on-hook
Disable Long space disconnect before
on-hook
Y
ATY1
Enable long
space disconnect
before on-hook
Disable Long space disconnect before
on-hook
N
ATZ0
Restore Stored
Profile 0
The modem has two profiles where
settings are stored. Type an
ampersand (&)W at the end of a
command to store settings in profile 0.
Designates profile 0 as the active
profile
Y
ATZ1
Restore Stored
Profile 1
Designates profile 1 as the active
profile
N