Filter
Top Products
47
Installing and removing storage
devices
The Altos G610 system supports one 3.5-inch and five 5.25-inch internal
storage devices. The empty drive bays allow you to install additional
drives such as a CD-ROM drive, a digital audio tape (DAT) drive or
another hard disk drive. These would provide your system additional
storage capacity.
Note: Your basic system already comes pre-installed with a CD-
ROM drive and a 3.5-inch floppy drive.
Replacing the 3.5-inch floppy drive
1 Remove the housing panels. Refer to page 38 for more detailed
instructions.
2 Disconnect the power and signal cables from the old drive.
3 Detach the old 3.5-inch drive with the drive frame from the
housing by removing the two chassis screws. Keep the screws for
later use.
4 Remove the four frame screws that hold the old drive to the drive
frame then pull out the drive.
5 Install a new 3.5-inch drive to the drive frame and secure it with
the four frame screws you have previously removed.
AA G600.book Page 47 Thursday, August 23, 2001 2:31 PM