Filter
Top Products
3 Upgrading your system
56
4 Push down the socket lever to lock the CPU into place.
Note: Install a terminator board into the CPU 2 socket if you only
install one CPU (must be installed in the CPU 1 socket). Also, make
sure to change jumper JP10 to setting 1-2 to indicate that you are
installing a terminator board into the CPU 2 socket. See
“Mainboard layout” on page 40 for the location of JP10.
5 Attach one side of the fan/heatsink metal bracket to the CPU
socket and then gently press down on the other side of the metal
bracket until it locks into place.
6 Connect the 3-pin and 2-pin fan/heatsink cables to the system
board. Refer to section “Mainboard layout” on page 40 for the
location of the fan/heatsink connectors.
AA G600.book Page 56 Thursday, August 23, 2001 2:31 PM