Filter
Top Products
11-5
Duralink64 Port Aggregation for NetWare
3 O
PTIONAL
. The Autodetect default detects which device the port is
connected to and adjusts the port speed and transmission mode
accordingly. Autodetect is recommended; however, to change the
connection type(s):
a Select the port, and then press Enter. (To select multiple
ports, select the port, and then press F5 one at a time.)
b In the Type of Connection menu, select the type, and
then press Enter. (Connection Types on page A-2 provides
descriptions.)
Figure 11-4. Type of Connection Menu
4 O
PTIONAL
. Enabled is the status default. To disable a port,
select the port and then press Tab.
5 When you are finished, press Esc to return to the Main Menu.
6 Continue to Creating Port Aggregation Groups on page 11-6.
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
1 Adptsf1
2 Adptsf2
3 Adptsf3
4 Adptsf4
5 Adptsf5
6 Adptsf6
7 Adptsf7
8 Adptsf8
No. Port Name NIC
Connection Type
Status
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
Autodetect (default)
10 Mbps/Half Duplex
10 Mbps/Full Duplex
100 Mbps/Half Duplex
100 Mbps/Full Duplex
Type of Connection