Filter
Top Products
7-3
Duralink64 Failover for Windows NT
5 Repeat steps 1 through 4 for each existing port.
6 When you are done, click OK.
7 Continue with Creating the Failover Pair.
Creating the Failover Pair
You can create Failover pairs in the Configuration tab. A Failover
pair consists of two ports only—the primary port and the backup
port.
Windows NT 4.0
To create Failover pairs, follow these steps:
1 From the Available Adaptec Ports box, click a port to be designated
as a primary port.
Figure 7-2. Failover Configuration Tab
2 Click Add. The port is added under Primary Port in the Failover Pair
list.
3 To assign a backup to the primary port, click the appropriate port
from the Available Adaptec Ports box, and then click Add. The port
is added in the Backup Port field.