Filter
Top Products
Chapter 3: Installing the Enclosure
40 Section I: Outdoor Installation
3. Wrap the tracer wire around the base of the post under the washer.
Wrap the aramid yard around the post at least four times, just above
the tracer wire and under the washer, and tighten the nut, as shown in
Figure 12.
Figure 12. Securing the Tracer Wire and Aramid Yarn
4. Trim the yarn back to the post.
Installing the
Armored Drop
Cable
To install the armored drop cable, perform the following procedure:.
1. Locate the fiber optic drop cable and ground wire entrance on the
enclosure, as shown in Figure 7.
Figure 13. Location of Fiber Optic Drop Cable and Ground Wire Entrance
2. Route the fiber optic drop cable to the enclosure entrance and mark
the entrance location on the cable.
3. Cut the cable 42 in. (106.7 cm) beyond the mark.
Tracer Wire
847
Tracer Wire
Aramid Yarn
All Countries: Install product in accordance with local and
National Electrical Codes.
E8
843
Fiber Optic Drop Cable and Ground Wire Enclosure Entrance