Filter
Top Products
Chapter 3: Installing the Enclosure
46 Section I: Outdoor Installation
5. Route the fiber cable 1-1/2 times around the splice tray to the splice
organizer and cut it to a length that will allow the splice to be placed in
the organizer, as shown in Figure 22.
Figure 22. Setting the Fiber Cable in the Splice Tray
6. Cut the SC/UPC pigtail cable (not provided) 29.25 in. (74.30 cm)
beyond the boot.
7. Strip the SC/UPC pigtail jacket to expose 13.75 in. (39.93 cm) of fiber.
8. Clean the fiber, and splice it to the pigtail, per the splice
manufacturer’s instructions.
9. Route the pigtail once around the splice tray and out through the upper
left corner and secure it with another wire tie, as shown in Figure 23.
Figure 23. Securing the Pigtail
The pigtail should extend 15.5 in. from the splice tray.