Filter
Top Products
Chapter 4: Installing the Gateway Outdoors
64 Section I: Outdoor Installation
Note
Do not connect the Ethernet cables to the gateway until the unit has
completed its bootup sequence. This may take several minutes if
network software upgrades are needed.
1. Remove the grommet from the LAN cable entrance, as shown in
Figure 42.
Figure 42. LAN Cable Entrance
2. Insert a UV-rated wire tie (not provided) through the slots at the bottom
of the entrance, as shown in Figure 43.
Figure 43. Inserting the Wire Tie
877
LAN Cable Entrance
881