Filter
Top Products
Stack Installation Guide for AT-2552XS L2 Data Center Switch
59
7. Refer to Table 9 on page 56 for the recommended fiber optic cable.
Insert the cable to the port on the transceiver, as shown in Figure 28,
until it snaps in place.
Figure 28. Attaching a Fiber Optic Cable to an SFP+ Transceiver
8. Repeat steps 6 and 7 for the cable installation into the remaining SFP+
transceivers that are installed.
Installing a SFP+
Direct Attach
Cables
The AT-SP10TW1, AT-SP10TW3 and AT-SP10TW7 10G direct attach
cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+
cable modules are ordered and supplied separately from the
AT-DC2552XS.
Perform the following procedure to install a SFP+ direct attach cables:
1. Remove the dust plug from a SFP+ slot on the switch. Refer to Figure
29.
Figure 29. Removing the Dust Plug from a SFP+ Slot