Filter
Top Products
23
System Unit Map
=================
Please select one of the following slots
Slot Description (Unit Type)
---- -------------------------------------------
1 IntraCore 3524 Unit
2 IntraCore 3524 Unit
3 IntraCore 3524 Unit
4 IntraCore 3524 Unit
5 IntraCore 3524 Unit
6 IntraCore 3524 Unit
7 IntraCore 3524 Unit
8 IntraCore 3524 Unit
Enter Unit Number (1 - 8) >
Exiting a Submenu
To exit a submenu, type q.
To exit a command line without changing the configuration setting (e.g., the “Set Password” option in the
User Interface Configuration Menu), press ctrl-c.
3.1 General Information
The General Information Screen displays the current operating information of the switch, such as its name,
IP address, and boot information.
To view General Information, type
g
from the Main Menu. A screen similar to that below appears.
IntraCore 3524 General Information Menu
System up for: 001day(s), 17hr(s), 27min(s), 54sec(s)
Software Version
Bank 1 Image Version/Date: 1.10/Dec 05 2001 13:54:06
Bank 2 Image Version/Date: 1.10/Dec 05 2001 13:54:06 (Running)
System Information
PROM Image Version/Date: 1.03D/Oct 06 2001 15:29:58
DRAM Size: 16.0MB Flash Size: 2.0MB
Config NVRAM Size: 64KB Console Baud Rate: 9600 bps
Administration Information
System Name: Test Stack
System Location:
System Contact:
System MAC Address, IP Address, Subnet Mask and Router
MAC Address: 00:00:94:CC:C7:6D
IP Address: xxx.xxx.xxx.xxx
Subnet Mask: 255.255.255.0
Router: 0.0.0.0
Bootstrap Configuration
Boot Load Mode: LOCAL
Press any key to continue...
Note: The information displayed on this screen is read-only.
To exit the General Information Screen, press any key on your keyboard.
3.2 Configuration Menu
The Configuration Menu allows you to manage and configure switch and each of its ports.
To access the Configuration Menu, type
c
from the Main Menu. The Configuration Menu appears, as shown
below (from a telnet session):