Filter
Top Products
54
To set the VLAN ID for the port (PVID), from the VLAN Port Configuration Menu, type
c
. Enter the number
you are assigning (from 1- 4094). Press Enter when you are done.
Adding and Deleting VLANs from the Port
To add or delete VLANs assigned to a port, type
a
to add, or
d
to delete from the VLAN Port Configuration
Menu. Follow the instructions on the screen.
Enabling and Disabling Port Ingress Filtering
By default, a port will accept and forward tagged frames whether or not the port is a member of a VLAN
matching the VID of the tagged frame. If ingress filtering is enabled, incoming tagged frames are forwarded
only if the port is a member of the VLAN matching the VID of the tagged frame. All other frames are dropped
and no addresses will be learned. To enable or disable ingress filtering on the port, type
v
to access the
Advanced Configuration submenu, and then type
f
to toggle port ingress filtering.
Configuring Port Receive Frame Type
By default, all ports on the switch receive both 802.1Q tagged frames and untagged frames. A port may be
configured to receive only 802.1Q tagged frames. This configuration is a necessary part of Inter-Switch Link
(ISL) configuration (see “Configuring Inter-Switch Links”). If a port is configured to receive only tagged
frames, any untagged frames received by the port are dropped and the source address of the untagged
frames is not learned.
Incoming tagged frames are forwarded to the VLAN whose VID is included in the tag header of the frame.
See “Enabling and Disabling Port Ingress Filtering” for more information about forwarding and filtering of
received tagged frames. To toggle the port between receiving all frames and receiving only tagged frames,
from the VLAN Port Configuration Menu, type e to access the Advanced Configuration submenu, and then
type t.
4.4.5 Displaying a Summary of VLAN Groups
To view a summary of VLAN groups, type v in the Configuration Menu to access the VLAN Management
Menu, then type d to access the VLAN Group Summary. A screen similar to the following appears:
IntraCore 3524 VLAN Group Summary
+-------+-----------+--------------+--------------------+
|VLAN ID|Mgmt Access| Created By | Status |
+-------+-----------+--------------+--------------------+
1 Enable Mgm Action Active, Independent
2 Enable Mgm Action Active, Independent
End of VLAN Summary, Port Vlan Summary Vlan Group Menu Vlan Group Info Menu
Quit
4.4.6 Displaying a VLAN Port Summary
To view a unit port VLAN summary, type v in the Configuration Menu to access the VLAN Management
Menu, then type
a
to access the Port VLAN Attribute Summary. Type the desired unit number and press
Enter. A screen similar to the screen below will appear. To view the summary for other units, type a
command as shown at the bottom of the screen.