Filter
Top Products
28
1. Open the SNMP Configuration Menu by typing n in the Configuration Menu.
2. Type d to Delete a Trap Receiver. A prompt for the entry of the trap receiver appears.
3. Enter the number of the entry you want to delete (1,2,3, or 4) and press
Enter
.
The trap receiver is deleted from the SNMP Trap Receivers list.
For further details on using SNMP, see Chapter 6 SNMP Management.
3.7 Port Configuration
The Port Configuration Menu allows you to manually configure each port of the switch for port speed,
duplex, and auto-negotiation. It also provides an overview of the entire system’s port operating status.
To access the Port Configuration Menu, type p in the Configuration Menu. A System Unit Map screen
appears. Type the unit number you wish to configure and press Enter.
System Unit Map
=================
Please select one of the following slots
Slot Description (Unit Type)
---- -------------------------------------------
1 IntraCore 3524 Unit
2 IntraCore 3524 Unit
3 <none>
4 <none>
5 <none>
6 <none>
7 <none>
8 <none>
Enter Unit Number (1 - 8) >
The Basic Port Configuration Menu appears.
IntraCore 3524 Basic Port Configuration Menu Unit Type: [IntraCore 3524 Unit]
Unit: [1] Port: [01]
Operating Status: -------- -------- -------- -K
Auto Negotiation: ******** ******** ******** **
Speed/Duplex: hhhhhhhh hhhhhhhh hhhhhhhh GG
Port Status: Enabled Link Status: Down
Auto-Nego: Enabled[ABCD] Link Speed: N/A
<Cmd> <Description>
h Help for Legends
t Toggle Port Status Enable/Disable
a Toggle Auto-Negotiation/Manual
l Toggle 10M/100M bps Link Speed
d Toggle Half/Full Duplex
r Restart Auto-Negotiation
v Advanced Port Configuration
g Global Port Configuration
q Return to previous menu
Command>
Select U)nit Nex)t unit Prev) unit S)elect port N)ext port P)rev port