Filter
Top Products
1-18
Chapter One
The Composite Audio/Video cable (C497-6) has a yellow, red, and white
RCA plug at each end. To connect an NTSC, PAL, or SECAM source to your
projector:
CABLE PROJECTOR PORT VCR CONNECTOR
(C497-6)
Yellow VIDEO 1 or 2. Video Out, To Monitor, etc.
White AUDIO 1 or 2 IN (white plug). Left Audio Out.
Red AUDIO 1 or 2 IN (red plug). Right Audio Out.
Connecting video from S-Video sources
The Desktop Projector 9100 can also project video from an S-Video source.
1 Connect one end of the S-Video cable (C466-6) to the Video Out
connector on the video source. The cable has identical round four-pin
connectors on either end.
2 Connect the other end of the cable to the projector’s S-VIDEO 1 port.
Connecting audio from the computer
Use the COMPUTER AUDIO IN port to connect audio from a computer.
1 Insert the mini jack end of the computer audio cable (C498-6) into the
AUDIO OUT connector of a Macintosh or the sound card of a PC.
2 Insert the RCA jacks at the other end of the computer audio cable into the
projector’s left and right COMPUTER AUDIO IN ports.
A
Computer
Audio In
Figure 1-23, Connecting audio from the computer
Connecting a microphone
To use a microphone while projecting an NTSC, PAL, SECAM, S-Video, or
computer image, plug an amplified or wireless microphone equipped with a
line level output (maximum 1 volt, peak-to-peak) into the MIC port.