Filter
Top Products
23
OmniView IP 5000 HQ
SECTIONS
Table of Contents
1 3 5 7 9 11 13 15 17 192 4 6 8 10 12
14
16
18
20 21
13
CONFIGURING TARGETS
2. From the toolbar, click . The “New Target” page appears;
see Figure 26.
Name – Type a unique name for each server in the system.
Figure 26 Creating a New Target – Access Services tab
7.1 Access Services tab
Here you select and configure all Access Services relevant to this target.
All Services/Active Services: From the “All Services” list, select the check
box of all Access Services relevant to this target. Once selected, the service
appears in the “Active Services” list.
Note! Below discusses how to configure Belkin IP devices. Configuring
other Access Services is discussed in the “Configuring Access Services for
Individual Targets” section on page 67.
The pre-installation guidelines on page 3 explained what information you
need to configure each target.
7.1.1 Default Access Service
You can set any of the Access Services to be the default service. This
means that the service will be used to access the target by default when
selecting the target by clicking its name. To access the target via a different
service, the service must be selected. To set a service as the default,
display the service as explained below and select the “Set as Default
Service” check box, circled in Figure 26.