Filter
Top Products
14
ETHERNET PRINT SERVER
After the EPS loads the Flash code and the unit is running normally, the
OK LED will blink once each 2 seconds. Depending on SW2’s position,
the EPS will print a greeting to the serial port when the unit is operational:
Ethernet Address: xx-xx-xx-xx-xx-xx IP Address:
undefined
Lantronix EPS1 Print Server
Diagnostics Report:
Interface: 10BASE-T
Memory: 256KB
Gate Array: Vers 3
Errors Reported: None
Attempting BOOTP: no reply received.
Attempting RARP: no reply received.
Checking 2 sections from flash:
From address .... -> not copied.
From address .....
Loaded 310260 bytes.
Load Completed - Boot in Progress
[10 lines of PostScript comments]
Lantronix EPS1 Print Server
Ethernet Address: xx-xx-xx-xx-xx-xx IP Address:
undefined
Fig. 3-2. Print Server Screen.
The server is now running normally. It will set the IP address if discovered via
BOOTP or RARP (or previously DEFINEd on the EPS). If the screen shown
in Fig. 3-2 does not appear, see Troubleshooting, Section 4.6. If garbled
characters appear on the console, check the terminal settings and the serial
cable and cycle power to the server.
When the screen in Fig. 3-2 appears, you can try to log into the EPS. Press
<Return> on the console and you will get a “Username>” prompt. Enter any
username and press <Return>. You will then be at the “Local>” prompt, and
can type “HELP” to get a list of EPS commands. See Section 4.0, Host
Configuration, or log out and attach your serial print device to the console
port. Remember to change SW2 to the On position if you will only attach a
print device to the serial port. Otherwise, the EPS will echo boot diagnostics
to the printer.