Filter
Top Products
59
APPENDIX C: Power-Up Tests
Table C-1. LED Patterns (continued).
LED State Meaning
• • • - (3 seconds) NVR check sum error: Ethernet address and other server
parameters are set to factory defaults. You will have to
restore the Ethernet address from the back label before
you can use the server. Contact Technical Support.
• • • • (3 seconds) Power-up tests passed. NVR checksum good, ready to
boot the terminal server.
• - - - (1/2 second) Indicates that the server has detected a factory default
- • - - (1/2 second) Ethernet address (00-00-00-00-00-00), and is
- - • - (1/2 second) investigating whether factory test hardware is present. It
- - - • (1/2 second) will attempt normal boot procedures within 3 seconds.