Filter
Top Products
CHAPTER 4 CONTROL PANEL
4–17
6. Press the ▲ or ▼ switch until the exit menu appears on the display.
exit MODE
7. Press the SET switch.
Then the printer automatically returns to the off-line ready state.
INTERFACE MODE
The automatic interface selection has been factory set. If you want to select
a specific interface manually, use the interface mode to set it.
Display Message Interface Mode
I/F=PARALLEL Parallel interface
I/F=RS-232C Serial interface
I/F=OPTION Optional interface for MIO card
I/F=AUTO Auto interface selection
Select the setting menu and enter the sub-setting menu to change the setting
as follows:
■ Automatic Interface Selection
When you use the automatic interface selection function, select the function
on the display as follows:
I/F=AUTO
When you select this function with the SET switch, the display shows the
next sub-setting menu as follows:
TIME OUT= 5s *
You need to set the time out for the auto interface selection from 1 to 99
seconds with the ▲ or ▼ switch: factory setting = 5 seconds. This time
out is the duration during which the printer will not allow another automatic
change to the interface.