Filter
Top Products
1-34
Test Print Mode
The printer has the following test print modes. Follow these steps:
☛ 1. Make sure that the front cover is closed.
☛ 2. Hold down the control panel button and turn on the power switch. Keep the button depressed
until the
Drum
LED comes on.
The
Drum
LED illuminates to indicate that the printer is in the test print mode.
☛ 3. Release the button and then press it again to execute the test print, or hold down the button to
select another option as shown in the table below and then release the button and press it again
to execute the selected option.
LED Lit Choice Function
Drum
Test Sample Page The printer prints a test sample page.
The printer returns to the Ready status after
printing.
Ready
Print Config &
Print Fonts I
The printer prints the current configuration
of the printer and a list of the internal fonts.
The printer returns to the Ready status after
printing.
Alarm
Factory Reset The printer is restored to the factory setting
and permanent fonts and macros are
cleared.
The printer returns to the Ready status after
printing.
Data
Hex Dump Print The printer can print data as hexadecimal
values so that you can check data errors and
problems. To exit from this mode, you
must turn off the printer.