Filter
Top Products
104
Drum End SoonX
1
1
(X) shows the drum
unit color that is near
the end of its life.
(BK)=Black,
(Y)=Yellow,
(M)=Magenta,
(C)=Cyan.
The drum unit for the color
indicated on the Touchscreen
is near the end of its life.
Order a new drum unit for the color indicated on
the Touchscreen before you get a Replace
DrumX message.
Drum ! The corona wires on the drum
units must be cleaned.
Clean the corona wires on the drum units (see
Cleaning the corona wires on page 82).
The drum unit or the toner
cartridge and drum unit
assembly is not installed
correctly.
Put the toner cartridge into the drum unit that is
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
Drum Stop It is time to replace the drum
unit.
Replace the drum unit for the color indicated on
the Touchscreen. (see Replacing the drum
units on page 86).
Fuser Error The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
Press and hold down to turn the machine
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
The fuser unit is too hot.
Jam 2-sided The paper is jammed
underneath the paper tray or
the fuser unit.
See Paper is jammed underneath the paper
tray on page 121.
Jam Inside The paper is jammed inside the
machine.
See Paper is jammed inside the machine
on page 118.
Jam Manual Feed The paper is jammed in the
manual feed slot of the
machine.
See Paper is jammed in the manual feed slot
on page 114.
Jam Rear The paper is jammed in the
back of the machine.
See Paper is jammed at the back of the
machine on page 116.
Jam Tray The paper is jammed in the
paper tray of the machine.
See Paper is jammed in the paper tray
on page 114.
Limit Exceeded The print limit set in Secure
Function Lock 2.0 was
reached.
Call your administrator to check your Secure
Function Lock Settings.
Log Access Error The machine could not access
the print log file in the server.
Call your administrator to check the Store Print
Log to Network settings.
For more information, see Network User's
Guide: Store Print Log to Network
Low Temperature The room temperature is too
low for the machine to operate.
Increase the room temperature to allow the
machine to operate.
Error Message Cause Action