Filter
Top Products
6
Outgoing Message (OGM) of External TAD
Timing is important in recording this message.
1
Record four seconds of silence at the beginning of your message. (This allows your machine
time to listen for the fax CNG tones of automatic transmissions before they stop.)
2
Try to record the shortest possible message on your telephone answering device (ideally less
than 20 seconds).
3
End your message by giving your Fax Receive Code for people sending manual faxes. For
example:
“After the beep, leave a message or send a fax manually by pressing 5 1 ( 9 1 for New
Zealand).”
Please note that some faxes that are sent manually cannot be received automatically because some
fax machines do not send a fax tone in manual mode. In these cases you must inform callers that they
must enter the remote Fax Receive Code to send a fax.
Sequence of External TAD Reception
When you leave your machine set in TAD mode, all calls will be answered by the externally
connected telephone answering device, and fax calls will be received automatically provided they
come from a machine which sends standard Calling tone (CNG).
Incoming Call
The call is picked up
by the TAD.
(Recommended short
TAD ring delay such
as 1 or 2 rings.)
The external TAD
outgoing message
begins (recommended
length of 10 seconds
or less).
The caller leaves a
voice message on the
external TAD.
The caller must press
Start or enter your
remote activation
code to activate the
machine and press
Start.
The fax message is
received on paper.
The caller can also
send a fax message
after the voice message.
Manual
fax call
Auto dial
fax call
Fax reception is
automatically
activated by
fax tone.
The fax message
is received on
paper.
Voice call