Filter
Top Products
12
Chapter 1
1
Setup
Initial Settings
Setting the Dialling Mode (Tone/Pulse)
(Not available in New Zealand)
Your machine is initially set to TONE. If you are using a PULSE dial line, you can change the
setting to PULSE by following the steps below.
1
Press Menu/Set, 1, 1. The screen prompts you to select TONE or PULSE.
2
Use or to select the dialling mode, and press Menu/Set when the screen displays the
dialling mode you want.
3
Press Stop/Exit.
Setting the Date and Time
The screen displays the date and time you set, whenever the machine is in stand-by mode. It will print
the date and time on every fax you send.
In the event of a power failure, the machine maintains date and time information for about 48 hours.
1
Press Menu/Set, 1, 2.
2
Enter the two digits of the year, and press Menu/Set. “04” is registered as 2004 in the machine.
3
Enter two digits for the month and press Menu/Set.
4
Enter two digits for the day and press Menu/Set.
5
Enter the time in 24 hour format and press Menu/Set.
6
Press Stop/Exit.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements for correct
operation. It is therefore strongly recommended that the equipment is set to use
the Tone signalling for access to public or private emergency services. The Tone
signalling also provides faster call set up.