Filter
Top Products
86
CHAPTER TEN
Remote Commands
Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Access Code (1 5 9 ), the system will signal
you with two short beeps to enter a remote control command.
Remote Control Commands
95 Changing Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List
2 Retrieve all faxes
3 Erase fax from the
memory
97 Check the receiving status
1 FAX
98 Change Answer Mode
1 TAD
2 FAX/TEL
3 FAX
90 Exit
Details Operation
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the conditions
have not been met (Example: registering paging number). You
can register your fax forwarding number by using 4. FAX
FWD NO (see page 87). Once you have registered the
number, the MFC will change automatically to FAXFWD:ON
mode. Then retrieve a Memory Status List by entering 961
(see page 87) to make sure that the Fax Forwarding number
you registered is correct in the List.
You can turn FAX STORAGE ON or OFF.
Enter the number of a remote fax machine to receive the
Memory Status List or stored fax message(s). (See page
86.)
If you hear one long beep, you can erase fax message(s)
from the memory.
You can check whether your MFC has received any fax
message(s). If yes, you will hear one long beep. If no, you
will hear three short beeps.
If you hear one long beep, you can change the Answer
Mode. If you hear three short beeps, you cannot change it.
After a long beep, you can exit remote control.