Filter
Top Products
39
INITIAL SETUP
Setting Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting is LOW.
When the beeper is set to LOW or HIGH, the MFC beeps every time you
press a key or make an error, and at the end of fax sending or receiving.
1
Press
Function
,
1
,
1
,
4
.
2
Press or to select your setting.
3
When the screen displays the setting you want, press
Set
.
4
Press
Stop
to exit.
Setting the Handset Volume
You can adjust the handset volume any time you are talking on the
telephone. There are two handset volume levels, LOW and HIGH. The
default setting is LOW.
Press or to adjust the volume level. The display shows the setting
you are choosing.
The new setting will remain until you change it again.
Setting the Speaker Volume (For MFC 7160C Only)
You can adjust the speaker volume when your MFC is on
Hook
—OR—
Speaker Phone
. You can turn the speaker off or you can select a speaker
volume level. The default setting is the lowest volume. (On the MFC
7150C, this will affect the volume of the one-way
Hook
speaker.)
Press or to adjust the volume level. The display shows the setting
you are choosing. Each key press changes the volume to the next setting.
The new setting will remain until you change it again.
If you have a MFC 7160C, you can adjust the speaker volume while you are
listening to your OGM (Outgoing Message) and ICMs (incoming messages).
If you turn the Incoming Recording Monitor to OFF (
Function
,
1
,
8
,
5
)
on the MFC 7160C, the Speaker for screening calls will be disabled and you
will not be able to hear callers leaving messages. The volume for other
operations can still be controlled using and .