Filter
Top Products
TeraStation User Manual 119
Network
Network
IP Address Settings
Click [Modify
Settings] to change
settings.
* The LAN cable
connected to LAN
Port 2 should be
set for Ethernet 2.
DHCP If enabled, DHCP will congure your IP settings automatically. A DHCP server on the
network is required for use.
Primary IP Address If DHCP is disabled, you can enter an IP address manually.
Subnet Mask Set a subnet mask.
Default Gateway
Address
Specify the IP address for a default gateway..
Primary DNS
Server
Specify an IP address of the primary DNS server.
Secondary DNS
Server
Specify an IP address of the secondary DNS server.
Wake on LAN Select [Enable] or [Disable] for [Wake on LAN].
* TS-XEL series TeraStations do not support Wake on LAN.
Ethernet Frame Size
Click [Modify
Settings] to change
settings.
* The LAN cable
connected to LAN
Port 2 should be
set for Ethernet 2.
Ethernet Frame
Size
You can improve transmission eciency by changing the maximum size of data that
can be sent at a time.
• [1518 bytes (Default)]: It is set to 1518 bytes at default.
• [4102 bytes (Jumbo Frame)]: Transfer at 4102 bytes.
• [7422 bytes (Jumbo Frame)]: Transfer at 7422 bytes.
• [9694 bytes (Jumbo Frame)]: Transfer at 9694 bytes.
Network Services
Network Services
[HTTP]: It is set to [Enable] by default.
* You cannot open the Web Admin interface from a network for which [Disable] is selected.
[HTTPS]: It is set to [Enable] by default.
* You cannot open the Web Admin interface through SSL from a network for which [Disable] is
selected.
[SMB]: It is set to [Enable] by default.
* You cannot access the TeraStation via SMB from a network where [Disable] is selected.
[AFP]: It is set to [Enable] by default.
* You cannot connect TeraStation via AFP from a Mac even if you add [AFP] in the shared folder
settings.
[FTP]: It is set to [Disable] by default.
* You cannot connect to the TeraStation via FTP from a Mac, even if you add [FTP] to the shared
folder settings.To use FTP, change this setting to [Enable].
[Backup/Replication]: It is set to [Enable] by default.
* You cannot use the TeraStation as a backup destination from a network connected for which
[Disable] is selected.
[NasNavi Detection]: It is set to [Enable] by default.
* If disabled, NAS Navigator2 will not be able to detect the TeraStation.
* NAS Navigator2 detection should be enabled to update rmware, use auto power
management, or use NS-SHIFT.
[NFS]: It is set to [Enable] by default.
* You cannot access the TeraStation from NFS clients if [Disable] is selected.
[SFTP]: It is set to [Enable] by default.
* You cannot access the TeraStation via SFTP if [Disable] is selected.
[WebAccess]: It is set to [Enable] by default.
* You cannot access the TeraStation via WebAccess feature if [Disable] is selected.
[TeraSearch]: It is set to [Enable] by default.
* You cannot use the TeraSearch if [Disable] is selected.
[Power Interlock]: It is set to [Enable] by default.
* You cannot use the auto power management if [Disable] is selected.
* If Ethernet 1 and 2 are both disabled, and the Power Mode Switch is set to AUTO, the
TeraStation will not turn on. Move the Power Mode Switch to MANUAL to allow the
TeraStation to power on again.
Add/Edit SSL Key Set when updating SSL Server certication and the private key.