Filter
Top Products
Finisher-AE1/Saddle Finisher-AE2/Puncher Unit-M1
3-35
3
Optional Equipment
CAUTION
If a finisher is attached to the machine, do not place your hand in the part of the
tray where stapling is performed or where the rollers are located, as this may
result in personal injury.
IMPORTANT
•
If the Staple mode is set, the output trays move downward as the stack of paper that is
output increases in quantity and thickness. Once an output tray has reached its stacking
limit, or after 30 sets of prints have been output, printing and stapling stop temporarily.
Remove all of the stapled prints from the output tray, and printing and stapling resume.
•
You can corner and double staple 11" x 17", LGL, LTR, LTRR, and EXEC paper.
•
You cannot staple transparencies, envelopes, tracing paper, or labels.
•
Do not pull copies or prints out of the output area while they are being stapled. Remove
the copies or prints after they are output to one of the output trays.
NOTE
•
The maximum number of sheets, including cover sheets, that can be stapled together is
as follows:
- LTR, EXEC
50 sheets (Main Document: 17 to 20 lb bond (64 to 80 g/m
2
); Cover Page: 17 to 32 lb
bond (64 to 128 g/m
2
))
- 11" x 17", LGL, LTRR
30 sheets (Main Document: 17 to 20 lb bond (64 to 80 g/m
2
); Cover Page: 17 to 32 lb
bond (64 to 128 g/m
2
))
•
If the machine stops while stapling and the message <Load staples.> appears, almost all
of the staples have been used, and the staple cartridge must be replaced. To proceed,
replace the staple cartridge. (See "Replacing the Staple Cartridge in the Stapler Unit," on
p. 7-36.)