Canon 3035 All in One Printer User Manual


 
Specifying Common Settings
4-55
4
Customizing Settings
NOTE
Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper
sizes are output to the same output tray in the same way as when Different Paper
Sizes for the Output Tray is set to 'On' when outputting to the Copy Tray-J1 or Buffer
Pass Unit-E2.
Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper size
may be output to the same output tray if there is only a small amount of paper in the
paper tray.
Clean the Original Scanning Area Prompt
You can use the Cleaning Display for the Original Scanning Area mode to prompt
you to clean the scanning area when the machine detects streaks or stains. If the
feeder is not clean, the machine will scan and print dust and grime on the output.
The Clean the Original Scanning Area Prompt appears when originals are placed in
the feeder. For instructions on cleaning the feeder's scanning area, see "Manual
Feeder Cleaning," on p. 7-53.
NOTE
[Cleaning Display for the Original Scanning Area] appears only if the optional Feeder
(DADF-N1) (standard-equipped for the imageRUNNER 3045/3035) is attached.
1
Press (Additional Functions) [Common Settings]
[Cleaning Display for the Original Scanning Area].
2
Select [On] or [Off] press [OK].
Limiting Functions
If a problem frequently occurs when using the Finishing modes, such as Offset
Collate and Staple, you can temporarily limit the use of these finishing modes by
setting Limited Functions Mode to 'On'.
In addition, when the Service Call Message screen appears indicating a finishing
mode malfunction and you temporally set the Limited Functions Mode to clear the
Service Call Message screen, you can deactivate the Limited Functions Mode by
setting this mode to 'Off' from the Additional Functions screen. However, after the
Limited Functions Mode is deactivated, the Service Call Message screen may
appear again, unless the cause of the malfunction is cleared. (See "Setting the
Limited Functions Mode from the Service Call Message Screen," on p. 8-102.)