Filter
Top Products
NetBIOS Network Setup Procedures
5-2
5
Using a NetBIOS Network
NetBIOS Network Setup Procedures
To use a NetBIOS network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
• The machine's control panel
• The Remote UI (via a web browser)
2
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 5-6.)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to
print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 5-11.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to
send data from the machine. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
IMPORTANT
•
If you are using the optional imagePASS, for steps 1 and 2, see the manual provided with
the optional imagePASS, not this guide.
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
The only base protocol supported by the machine for NetBIOS networks is TCP/IPv4.
TCP/IPv6 and NetBEUI are not supported (SMB is used as a print application).