Filter
Top Products
Loading Roll Media
17
2-17
Note
z While roll media is loaded in the printer, avoid opening and closing the roll media
tray. Opening and closing the tray causes the printer to cut the leading edge of the
roll media and consume paper.
z You should remove each sheet output to the output stacker, one at a time.
z Before shipping a dye ink printer, the Media Type is set for “Plain Paper”.
z Before shipping a pigment ink printer, the Media Type is set for “Heavy Coated”.
z It is recommended that the special settings (1 to 5) be used when smudges and
blots appear on the print density is too light while printing on one of the media
types listed above. The Special settings determine in 5 steps the amount of ink used
on the surface of the media. The higher the number in the range of 1 to 5, the
greater the amount of ink used. The setting may require testing and adjustment,
depending on the media in use and the content of the image.
z The media size is detected automatically, therefore no setting for the size is
required.
z In order to align the leading edge correctly when the roll media is replaced with a
new one, the paper is fed approximately 100 mm (4 in.) then cut.