Filter
Top Products
11
Send designated commands to the RE-350
for control.
Set the RE-350 to [O
FF
-L
INE
] Mode.
In order to put the RE-350 in [O
FF
-L
INE
]
Mode, the following two methods will be
available:
1. Push the {RS-232} button on
the front panel.
2. The PC sends the [O
FF
-L
INE
]
command to the RE-350.
Turn off the main power on the RE-350.
The RE-350 will operate according to the given
commands. (Refer to Section 2.0)
1. The RE-350 will send Request Off Line event data to
the PC and the RS-232 LED will blink.
2. After the reception of <Accepted> E-response data, the
RE-350's status shifts to [O
FF
-L
INE
] mode and the RS-
232 LED
will turn off. If the RE-350 receives <Denied>
E-response data, the RE-350 stays in [O
N
-L
INE
] Mode
and the RS-232 LED remains on.
If the PC does not respond in one second with E-
response data, the RE-350 will repeat Request Off Line
event data up to twice and if still no E-response data,
the RE-350 stays in [O
N
-L
INE
] Mode and maintains RS-
232 LED
on. (Refer to Section 2.5)
The RE-350 responds with C-response data and it shifts to
[O
FF
-L
INE
] Mode and the RS-232 LED turns off.
The main power of the RE-350 will be off and every LED
will be off.
Order
RE-350's Condition and LED StatusOperations
8
9
10