Filter
Top Products
12
1.3.3 Procedure for Using the Control Knobs
[O
FF
-L
INE
] Mode
[O
N
-L
INE
] Mode
[N
OTIFICATION
] Mode
Mode Meaning
Adjusting the value of each control knob.
The physical position of each control knob on the front panel is used to measure and
adjust it's respective value.
Setting the center target value for Auto-White Balance.
The physical position of the white balance control knob will be used as the center
value to measure and adjust the white balance.
Adjusting the value of each control knob.
The physical position of each control knob on the front panel will be disregarded
and the value of the “command data packet” from the PC will be used to measure
and adjust the control knob's respective value.
Setting the center target value for Auto-White Balance.
The control knob's physical position will be saved into the Auto-White Balance
position buffer when the RE-350 shifts to [O
N
-L
INE
] Mode. If the PC gives the
proper command data to set the Auto-White Balance control knob's position, the
buffer data will be updated.
Adjusting the value of each control knob..
The physical position of each control knob on the front panel will be disregarded
and the value of the “command data packet” from the PC will be used to adjust the
control's respective value.
Setting the center target value for Auto-White Balance
The control knob's physical position will be saved into the Auto-White Balance
position buffer when the RE-350 shifts to [O
N
-L
INE
] Mode. If the PC gives the
proper command data to set the Auto-White Balance control knob's position into
the buffer, the given data will be updated.
Note:
When the mode of the RE-350 shifts from [O
N
-L
INE
] Mode or [N
OTIFICATION
] Mode to [O
FF
-L
INE
] Mode, the
center target value for Auto-White Balance will be changed from the value in the Auto-White Balance control knob
position buffer to the physical position of the Auto-White Balance control knob automatically. The manual white
balance data given from the PC will be disregarded.