Filter
Top Products
E-109
4. Use
e
and
d
to move the cursor around the program, and perform the required
operations to edit the contents of the program or to add new contents.
• You can press
1
f
to jump to the beginning of the program, while
1
c
jumps to
the end.
5. After program contents are the way you want, press
J
.
k
Running a Program
An existing program can be executed from the COMP Mode, BASE-N Mode, or PROG
Mode.
Note
• If you run a program from the PROG Mode, pressing
E
or
J
after the program is
complete will return to the Prog List or Fmla List screen. Since the name of the program
you just ran will be highlighted on the Prog List or Fmla List screen, you can run it again
by pressing
E
.
• If you run a program from the COMP Mode or BASE-N Mode, pressing
E
after the
program is complete will run the same program again. Pressing
J
will not perform any
operation.
• To interrupt ongoing program execution, press
o
.
A
Running a Program from the Prog List or Fmla List Screen
1. Perform either of the following operations.
- While the Program Menu screen is on the display in the PROG Mode, press
2
(RUN).
- In the COMP or BASE-N Mode, press
/
.
• This displays the Prog List screen or Fmla List screen.
2. Press
e
or
d
to switch between the Prog List and Fmla List screen.
To run a program with this run mode: Display this screen:
COMP or BASE-N Prog List screen
Formula Fmla List screen
3. Use
c
and
f
to move the highlighting to the name of the program you want to run
and then press
E
.
• This runs the program.
Note
After you run a program, you can press the
o
key to manually interrupt program
execution. This displays a screen like the one shown below.