Filter
Top Products
3-5
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Chapter 3 Mounting and Alignment Overview
LEDs
LEDs
The LEDs indicate the startup status, operating mode, association status, and received signal strength.
This information simplifies the process of activating the link and positioning the antenna from the
access point/bridge mounting location. The LEDs are mounted on the back of the housing (see
Figure 3-2).
Figure 3-2 LEDs
When the access point/bridge running Cisco IOS 12.3(4)JA is initially powered-up, the unit defaults to
a root access point with the radio disabled and no default SSID. To allow client associations, you must
configure an SSID and enable the radio interface (refer to the “Configuring the Access Point/Bridge for
the First Time” section on page 5-1).
When the access point/bridge running Cisco IOS 12.3(2)JA2 and earlier is initially powered-up, the
bridge installation mode is activated and the unit attempts to associate to a root bridge for 60 seconds.
If it is unable to associate with a root bridge, it automatically assumes the root bridge role.
R Radio LED E Ethernet LED
S Status LED I Install LED
117061
RS
I
E