Filter
Top Products
5-8
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Chapter 5 Configuring the Access Point/Bridge for the First Time
Assigning Basic Settings
• Aironet Extensions—Enable this setting if there are only Cisco Aironet devices on your wireless
LAN and the unit is operating as an access point or workgroup bridge.
Step 6 Click Apply to save your settings. If you changed the IP address, you lose your connection to the access
point/bridge. Browse to the new IP address to reconnect to the access point/bridge.
Default Settings on the Express Setup Page
Table 5-1 lists the default settings for the settings on the Express Setup page.
Table 5-1 Default Settings on the Express Setup Page
Parameter
Default Setting
Cisco IOS Release 12.2(15)JA
Cisco IOS Release 12.3(2)JA2 or
later
System Name or
Host Name
bridge ap
Configuration Server
Protocol
DHCP DHCP
IP Address Assigned by DHCP
1
(default
setting); if DHCP is disabled, the
default setting is 10.0.0.1
1. After a static IP address is assigned or the role is changed from Install, the SSID is automatically changed to tsunami.
Assigned by DHCP by default
2
2. If an access point/bridge running Cisco IOS Release 12.3(2)JA2 or later software with a default configuration does not receive
an IP address from your DHCP server, it continues to send DHCP requests indefinitely.
IP Subnet Mask Assigned by DHCP (default setting);
if DHCP is disabled, the default
setting is 255.255.255.224
Assigned by DHCP by default
Default Gateway Assigned by DHCP (default setting);
if DHCP is disabled, the default
setting is 0.0.0.0
Assigned by DHCP by default
SNMP defaultCommunity defaultCommunity
Read Only Read Only
Role in Radio Network Install mode
3
3. During install mode, the SSID is autoinstall.
Access point (root)
Optimize Radio Network
for
Throughput Throughput