CHAPTER
6-1
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
6
Using the Command-Line Interface
This chapter describes the IOS command-line interface (CLI) that you can use to configure your access
point/bridge. It contains these sections:
• Connecting to the Console Serial Port, page 6-2
• Using a Telnet Session to Open the CLI, page 6-3
• IOS Command Modes, page 6-4
• Getting Help, page 6-5
• Abbreviating Commands, page 6-5
• Using no and default Forms of Commands, page 6-5
• Understanding CLI Messages, page 6-6
• Using Command History, page 6-6
• Using Editing Features, page 6-8
• Searching and Filtering Output of show and more Commands, page 6-10
• Assigning an IP Address Using the CLI, page 6-11
• Finding the Access Point/Bridge IP Address Using the CLI, page 6-11