Filter
Top Products
6-7
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Chapter 6 Using the Command-Line Interface
Using Command History
Changing the Command History Buffer Size
By default, the access point/bridge records ten command lines in its history buffer. Beginning in
privileged EXEC mode, enter this command to change the number of command lines that the access
point/bridge records during the current terminal session:
br# terminal history [size number-of-lines]
The range is from 0 to 256.
Beginning in line configuration mode, enter this command to configure the number of command lines
the access point/bridge records for all sessions on a particular line:
br(config-line)# history [size number-of-lines]
The range is from 0 to 256.
Recalling Commands
To recall commands from the history buffer, perform one of the actions listed in Table 6-4:
Disabling the Command History Feature
The command history feature is automatically enabled.
To disable the feature during the current terminal session, enter the terminal no history privileged
EXEC command.
To disable command history for the line, enter the no history line configuration command.
Table 6-4 Recalling Commands
Action Result
Press Ctrl-P or the up arrow key.
1
1. The arrow keys function only on ANSI-compatible terminals such as VT100s.
Recalls commands in the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
Press Ctrl-N or the down arrow key.
1
Returns to more recent commands in the history buffer after recalling commands
with Ctrl-P or the up arrow key. Repeats the key sequence to recall successively
more recent commands.
show history While in privileged EXEC mode, lists the last several commands that you just
entered. The number of commands that are displayed is determined by the setting
of the terminal history global configuration command and history line
configuration command.