Filter
Top Products
8-13
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Chapter 8 Cisco Transport Controller Operation
8.5.3 Card View
8.5.3 Card View
Card view provides information about individual ONS 15454 SDH cards (Figure 8-7). Use this window
to perform card-specific maintenance and provisioning. A graphic showing the ports on the card is
shown in the graphic area. The status area displays the node name, slot, number of alarms, card type,
equipment type, and the card status (active or standby), card state if the card is present, or port state
(Table 8-6 on page 8-8). The information that appears and the actions you can perform depend on the
card. For more information about card service states, see Appendix B, “Administrative and Service
States.”
Figure 8-7 Card View
Note CTC provides a card view for all ONS 15454 SDH cards except the TCC2, TCC2P, XC10G,
XC-VXL-10G, and XC-VXL-2.5G cards. Provisioning for these common control cards occurs at the
node view; therefore, no card view is necessary.
Use the card view tabs and subtabs, shown in Table 8-12, to provision and manage the ONS 15454 SDH.
The subtabs, fields, and information shown under each tab depend on the card type selected. The
Performance tab is not available for the AIC-I card.