Filter
Top Products
C-65
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Appendix C Network Element Defaults
C.3 Node Default Settings
C.3 Node Default Settings
Table C-24 lists the Cisco ONS 15454 SDH node-level default settings for the Cisco ONS 15454 SDH.
Cisco provides the following types of settings preprovisioned for each Cisco ONS 15454 SDH node:
• SNCP settings determine whether SNCP circuits have SD BER and SF BER monitoring enabled, are
revertive, and what the reversion time is.
• Craft Access Only allows CTC connectivity to the node only through the craft access port.
• CTC IP Display Suppression prevents display of node IP addresses in CTC.
• Defaults Description lists the current defaults file on the node.
• Enable Firewall enables or disables the use of a firewall for accessing the node.
• Enable Proxy enables or disables the use of a proxy server with the node.
• IIOP Listener Port sets the IIOP listener port number.
• LCD IP Setting sets the node LCD screen to display the node IP address and use the buttons on the
LCD panel, only display the IP address, or suppress display of the IP address.
• Login Warning Message warns users at the login screen about the possible legal or contractual
ramifications of accessing equipment, systems, or networks without authorization.
• NTP SNTP Server sets the IP address of the NTP SNTP server to be used with the node.
• Time Zone sets the time zone where the node is located.
• Use DST enables or disables the use of Daylight Savings Time.
• Use NTP SNTP Server enables or disables the use of the specified NTP SNTP server with the node.
• LMSP protection settings determine whether or not LMSP-protected circuits have bidirectional
switching, are revertive, and what the reversion time is.
• MS-SPRing Protection Settings determine whether MS-SPRing-protected circuits are revertive and
what the reversion time is at both the ring and span levels.
• Y Cable Protection Settings determine whether Y-Cable protected circuits have bidirectional
switching, are revertive, and what the reversion time is.
• Security Policy settings determine the failed logins before lockout, idle user timeout for each user
level, lockout duration, manual unlock user level enabled, password reuse timeout and threshold,
and single session per user for the node security.
• BITS Timing settings determine the AIS threshold, coding, and framing for BITS1 and BITS2
timing.
• General Timing settings determine the mode (internal or external), quality of RES, revertive,
reversion time, and SSM message set for node timing.
Table C-24 Node Default Settings
Default Name Default Value Minimum Maximum
NODE.circuits.sncp.HO_SDBER 1e-006
NODE.circuits.sncp.HO_SFBER 0.0001
NODE.circuits.sncp.LO_SDBER 1e-005
NODE.circuits.sncp.LO_SFBER 0.001
NODE.circuits.sncp.ReversionTime 5