Filter
Top Products
12-22
Cisco ONS 15454 SDH Reference Manual, R5.0
April 2008
Chapter 12 CTC Network Connectivity
12.3 Provisionable Patchcords
Provisionable patchcords are required on both ends of a physical link. The provisioning at each end
includes a local patchcord ID, slot/port information, remote IP address, and remote patchcord ID.
Patchcords appear as dashed lines in CTC network view.
Table 12-5 lists the supported card combinations for client and trunk ports in a provisionable patchcord.
Note If the OCSM card is installed in Slot 8, provisionable patchcords from OC-N ports to the following cards
are not supported on the same node: MXP_2.5G_10G, TXP_MR_10G, TXP(P)_MR_2.5G,
MXP_2.5G_10E, TXP_MR_10E, 32MUX-O, 32DMX-O, 32-WSS, or 32-DMX.
Table 12-6 lists the supported card combinations for client-to-client ports in a patchcord.
Table 12-5 Cisco ONS 15454 SDH Client/Trunk Card Combinations for Provisionable Patchcords
Trunk Cards
Client Cards
MXP_2.5G_10G/
TXP_MR_10G
TXP(P)_MR_
2.5G
MXP_2.5G_10E
/
TXP_MR_10E
32MUX-O
32DMX-O
32-WSS/
32-DMX ADxC 4MD
MXP_2.5G_10G/
TXP_MR_10G
———YesYesYesYes
TXP(P)_MR_2.5G ———YesYesYesYes
MXP_2.5G_10E/
TXP_MR_10E
———YesYesYesYes
MXP(P)_MR_2.5G ———YesYesYesYes
OC-192 Yes — Yes ————
OC-48 Yes Yes Yes ————
OC-192 ITU ———YesYesYesYes
OC-48 ITU ———YesYesYesYes
Table 12-6 Cisco ONS 15454 SDH Client/Client Card Combinations for Provisionable Patchcords
Client Cards
MXP_2.5G_10G/
TXP_MR_10G TXP(P)_MR_2.5G
MXP_2.5G_10E/
TXP_MR_10E
MXP_2.5G_10G/
TXP_MR_10G
Yes — Yes
TXP(P)_MR_2.5G —Yes—
MXP_2.5G_10E/
TXP_MR_10E
Yes — Yes