Filter
Top Products
10
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
OL-5788-01
Configuring the Router
Verifying the Hardware Configuration
To display and verify the hardware features, enter the following commands:
•
show version—Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and
flash memory.
•
show diag—Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters; typical examples are network modules, interface cards (VICs, WICs,
HWICs), and advanced integration modules (AIMs).
Configuring the Router
This section covers the following topics:
•
Initial Configuration Using Cisco Router and Security Device Manager, page 5
•
Initial Configuration Using the Setup Command Facility, page 5
•
Initial Configuration Using the Cisco CLI—Manual Configuration, page 8
•
Verifying the Initial Configuration, page 9
•
Completing the Configuration, page 9
You can configure your router by using one of the following tools:
•
Cisco Router and Security Device Manager—See the “Initial Configuration Using Cisco Router and
Security Device Manager” section on page 5.
•
Setup command facility—See the “Initial Configuration Using the Setup Command Facility” section
on page 5.
•
Command-line interface (CLI)—See the “Initial Configuration Using the Cisco CLI—Manual
Configuration” section on page 8.
AUX/
PWR
Green IP phone power operating normally (if installed), or
Cisco Redundant Power System (RPS) operating normally (if installed)
Amber IP phone power fault (if installed), or
Cisco Redundant Power System (RPS) fault (if installed)
Off IP phone power and Cisco RPS are not installed
SYS
ACT
Blinking green or solid green Packet transfers are occurring or internal monitoring activities are
occurring
Off No packet transfers are occurring
CF Blinking green or solid green Flash memory is being accessed; do not eject the CompactFlash memory
card
Off Flash memory is not being accessed; okay to eject the CompactFlash
memory card
Table 1 Cisco 2800 Series LED Indicators
LED Label LED Color or State Meaning